![]() ![]() ![]() Put a value in the transverse, but make it Negative, such as -5.25, in whatever units you are using. It really doesn't matter whether the extrusion is horizontal or vertical, although it is convenient if you have a vertical edge to extrude off of because then you don't have to rotate it. The Extrude button will light up (it, like most of the buttons are greyed out when not activated.) When you click on the extrude button a dialogue box will pop up asking for a distance in the x, y or z plane (x is longitudinal, Y is transverse and Z is vertical distance above the baseline). Usually any edge that is on the outside of your design is a boundary edge, but the only way to find out is to try it. What the Heck is that? Well, the centerline is a boundary edge. My method for inserting bulkheads is fairly simple but has a lot of steps to it.įirst you need to use the Extrude command in the Edge group. I had many difficulties but most of them actually have easy solutions once you dig them out of the jargon. Delftship can be rather daunting and you are right, many of the tutorials leave out a lot of steps and are aimed at experienced users. I have used Freeship and am now using Delftship.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |